Fermentation tank:

Fermentation tanks are widely used in beverage, chemical, food, dairy, condiments, brewing, pharmaceutical and other industries for fermentation. According to the growth and metabolism needs of microorganisms, they are divided into aerobic fermentation tanks and anaerobic fermentation tanks. Aerobic fermentation tanks are divided into mechanical stirring and ventilation fermentation tanks and non-mechanical stirring and ventilation fermentation tanks;

The components of the fermentation tank include: the tank body is mainly used to cultivate and ferment various bacteria, and it must have good sealing (to prevent the bacteria from being contaminated). There is a stirring paddle in the tank body for continuous stirring during the fermentation process; there is a ventilated Sparger at the bottom to allow air or oxygen required for bacterial growth; there are control sensors on the top plate of the tank body, the most commonly used are pH electrodes and DO electrodes, which are used to monitor changes in the pH and DO of the fermentation liquid during the fermentation process; the controller is used to display and control the fermentation conditions.

Mechanical stirring fermentation tank. This equipment adopts internal circulation mode, uses stirring paddle to disperse and break bubbles, it has high oxygen dissolution rate and good mixing effect. The tank body is made of SUS304 or 316L stainless steel, and the tank is equipped with an automatic spray cleaning head to ensure that the production process meets GMP requirements.

Structural characteristics

1. Online CIP cleaning and SIP sterilization (121°C/0.1MPa) are possible.

2. Designed according to sanitary requirements, the structure is very user-friendly and easy to operate. The transmission is stable and the noise is low.

3. Suitable diameter-to-height ratio design, customized stirring device, energy saving,Stirring、FermentationThe effect is good.

4. Inner tank surfaceMirror polishingProcessing (roughness Ra ≤ 0.4μm); each inlet and outlet,Sight GlassThe welding places of process openings such as manholes and the inner tank body are all made of arc transition by stretching and flanging process, which is smooth, easy to clean and has no dead angle, ensuring the reliability and stability of the production process and meeting the requirements of "GMP" and other regulations.

5. Mixer (multi-stage or stepless speed change). Sterile breathing vent (or sterile positive pressure device)

6. Inlet and outlet. Sterile sampling port

7. Manhole. Cold and hot water inlet and outlet

8. Thermometer. CIP cleaning spray head

?

?

?